Shaft Heating
GOLFSMITH Leverage Block
Back by popular demand and still the best way to break loose an iron head from a steel shaft (not intended for use with graphite shafts).
ASSORTED Pro-Torch
An effective and affordable method for heating metal woods and irons for easy shaft removal. Especially good for removing heat-sensitive graphite shafts because the Pro Torch discharges a tighter flame that is easier to control than bulky propane torches.
GOLFSMITH Black & Blue Remover
Did you hold the heat on for to long? Then you need Blue Away! Blue Away is specially formulated compund used to remove black and blue heat stains from iron and metal wood hosels after reshafting. Rub it on and buff it off. - Available in a 2.5 oz. bottle.
GOLFSMITH Straight Shaft Remover-Iron
A favored tool in our own repair shop. Lightly tap the device into the broken shaft, apply heat to the hosel, and then gently turn the device to remove, using an Offset Handle or vise grips. Universal 95-98% success rate, even on iron shafts broken flush with the hosel.
GOLFSMITH Straight Shaft Remover-Wood
A favored tool in our own repair shop. Lightly tap the device into the broken shaft, apply heat to the hosel, and then gently turn the device to remove, using an Offset Handle or vise grips. Universal 95-98% success rate, even on iron shafts broken flush with the hosel.
GOLFSMITH Graphite Shaft Pry Bar
Straight pulling motion allows re-use of the shaft every time. This pry bar is also handy for shafts that get stuck in the hosel on dry runs. The 15 bars end grooves fit wood shaft diameters on one end of the tool and iron shafts on the other.
GOLFSMITH Hosel Protectors Woods/Irons
Recommended for use with any shaft removal device. Hosel Collars protect hosels from nicks and scratches during shaft removal.Especially useful for aluminum metal wood hosels. Sold in packages of six (three for wood shafts; three for iron shafts).
ASSORTED Electric Heat Gun
Allows you to pull shafts at the instant the epoxy bond is broken without damaging graphite shafts or heads; safer for clubhead finishes. Also good for loosening inserts and fast drying.
GOLFSMITH 48 Inch Heating Rod (Steel And Graphite Set)
Extra-Long 48 Rods for Full-Length Shafts. Hot Rods have always been the best method for breaking the epoxy bond and removing a steel shaft fully intact -- especially from clubhead materials that should not receive direct heat.
GOLFSMITH 12 Inch Graphite Shaft Heating Rod
12 Hot Rod for Graphite Hot Rods have always been the best method for breaking the epoxy bond and removing a steel shaft fully intact -- especially from clubhead materials that should not receive direct heat.